So you will be using the ground from your PSU on your control ports. The ground really isn't needed since the PCB uses the same ground that is supplied from your Supergun. Since we will be using a DB9 male connector on the SG we need to use a DB9 female connector for the kick harnesses.Īs you can see in the above picture we will be using pins 9, 15, 17, 19, 21 and 23. Now since we already have our pinout planned we have to standardize the kick harnesses themselves. For Mortal Kombat K1 will be Low Punch, K2 will be Block and K3 will be Low kick. Now with this pinout Capcom games will have the kick buttons in the K1, K2 and K3 area. This pinout is of course assuming you will be using a standard 6 button setup on your controls. Now below is the pinout on the DB9 for what we will be using:
The Male end is what you see on the plug side of the DB9 and the Female is what you see on the solder side of the DB9. This way you have enough pins to cover everything. The easiest way is to use a DB9 connector. To make things easier for you it is best to standardize your kick harness setup.
As you can see below the Capcom CPS2 kick harness has way more pins than the Mortal Kombat kick harness.ĭifferent arcade PCB makers use differnt pinouts and patterns some times on their kick harnesses. For our tutorial will will be using a Capcom CPS2 and Midway Mortal Kombat kick harness.
To add multiple kick harnesses to your setup you first need to determine which kick harnesses you need.
0 kommentar(er)
